Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

1999 Pontiac Sunfire Key Fob Programming Instructions

1999 Sunfire

  1. Make sure ignition is in the OFF position.
  2. Locate the programming connector in the trunk (drivers side). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You may have to pull back trim to access connector.
  3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. Make sure the terminals remain connected throughout the programming procedure.
  4. Press the LOCK and UNLOCK buttons on the remote simultaneously. In response the Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been accepted and all existing remotes have been erased.
  5. Repeat the previous step for each additional remotes (including any exsisting remotes) Do not remove jumper wire in between programming of remotes.
  6. Remove the jumper wire from the Keyless Remote Connector.