Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

2003 Pontiac Montana Key Fob Programming Instructions

2003 Montana

IMPORTANT: Before entering programming mode, have in possession all of the remotes you will be useing on the vehicle. Once you program the remote. all previous remotes that were programmed will be erased from memory. The other remotes will not be functional until you program the them again.

  1. Remove key from ignition.
  2. Remove the "BCM PRGRM" fuse from the fuse panel, accessed by opening the front passenger door. Use the legend on the fuse panel to properly locate the "BCMPRGRM" fuse.
  3. Close all of the doors.
  4. Close the liftgate.
  5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you –the opposite direction from starting the engine).
  6. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
  7. Open and close any vehicle door. A chime will be heard when the system enters the programming mode.
  8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds.

    IMPORTANT: After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming. Your new remote has been accepted and all existing remote codes have been erased.

  9. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters).
  10. Remove the ignition key from the ignition lock cylinder.
  11. Install the "BCM PRGRM" fuse back into the fuse panel.