Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

2000 Chevrolet Express Van Key Fob Programming Instructions

2000 Express Van

  1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4.

    (Note port is wider at top) Your OBDII port will not
    have numbers, use this diagram for reference.

    Chevrolet Express Van data link port
  2. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.
  3. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and unlocking the doors. Release the buttons on the transmitter.
  4. Within one minute, repeat the previous step on the remaining transmitters to be programmed.
  5. Remove jumper wire applied to th OBDII Port.