Disclaimer: The information in this site is provided to you as a free service. We strive at ProgramAutoRemote.com to have the most current and accurate information. ProgramAutoRemote.com and its creators assume no responsibility for the accuracy or inaccuracy of the information provided.

spacer

1996 BUICK Century Key Fob Programming Instructions

1996 Century

  1. Locate the green programming connector located in the LH trunk. Trim may have to be pulled back to access programming connector. ( Connector has wires leading up to it and it is not connected to anything.)
  2. Jump programming connector terminals.
  3. System should now lock and unlock doors and trunk lid to indicate programming mode has been entered. Trunk lid must have activated before proceeding.
  4. Press any button on keyless remote once. System should now lock and unlock doors and trunk lid, indicating successful programming of keyless remote. Trunk lid must have activated before proceeding.
  5. Repeat step 4 for additional remote or other existing keyless remote.
    NOTE: A maximum of only two Keyless Remotes can be programmed.
  6. Remove programming connector jumper wire to exit programming mode.
  7. Test remote(s).